|
The Turnigy Mobius gimbal is a low cost, light weight, quality
component 2-Axis gimbal to match the Mobius’s smaller size. It comes
with quality Turnigy AX-2206 motors, perfect for their small size and
being well known as a great motor. The performance of the 8-Bit Mini
Alexmos BGC is robust enough to satisfy the most demanding user and with
the Basecam software, it is a powerful tool for setup and tuning.
We pulled out the defibrillator and shocked some serious life in to
the Dead Cat conversion! The defibrillator power core effortlessly
supplies a regulated, filtered and RF noise shielded 5 volts at a
whopping 3 amps for the flight controller and 12 volts at 1 amp for the
hungriest of video transmitters. The camera power can be selected to
either 5 volts or 12 volts depending on your camera’s requirements. The
lower frame has direct solder pads for the motor ESC power lines right at the base of the arms and an XT60
connector for the battery at the rear to minimize cabling. The frame
comes with power connectors at the front for your Mobius camera and
gimbal, in the middle for your flight controller and at the rear for
your video transmitter. The video connectors at the front and rear not
only supply the voltage but also carry the audio and video signals from
the front mounted camera to the rear mounted video transmitter with
extra filters to eliminate any stray noise picked up between camera and
the video transmitter.
The arms come from our popular S550 kit and are made of glass fiber
with an inserted carbon fiber rod giving great strength. The arms are
upswept to give greater stability and provide faster forward flight.
This kit includes everything necessary into to this wicked camera rig.
Clean up your layout and improve reliability by reducing connection failures. I guess this Dead Cat has 9 lives after all!
Features:
• Frame kit with 2-axis brushless gimbal and controller for Mobius camera
• AX2206 Gimbal motors
• Aexmos Gimbal controller
• Large 500mm wheelbase
• Integrated power distribution, with camera and video transmitter integrated wiring
• "Defibrillator" power shield
• Power and A/V distribution on lower frame
• Glass fiber arms reinforced with carbon fiber rod for extra strength
Specs:
Gimbal controller: DYS 8bit mini Alexmos controller
Gimbal motor: Ax-2206 80T Turnigy Motor (with MX 1.5 3-pin connector)
Wheelbase: 500mm
Front arm width: 410mm
Rear arm width: 410mm
Dimensions (assembled): 452x326x183mm
Frame weight (with brushless gimbal and gimbal motors): 550g
Included:
Lower main frame plate
Upper main frame plate
Mobius Gimbal
All necessary hardware
Required:
Mobius Camera
Motors
Prpellers
ESC
Flight controller
Redio TX / RX
| 
